Tsymo Pet Feeder Manual Pdf (2024)

FAQs

How to reset automatic pet feeder? ›

On the front of the Smart Pet Feeder, you will find the 'feed' button. Press the 'feed' button for 5 seconds. When you hear a beep after about 5 seconds, this indicates that the reset has been performed successfully and the Smart Pet Feeder has been reset to factory settings.

To Set Time: 1. After powering feeder, the LCD will show a blinking 12 for time format setup. Use UP or DOWN buttons to scroll to select 12 hour or 24 hour time format. Press RIGHT button to set time.

Reset the feeder to factory settings, holding down the Add Pet ( ) button for 10 seconds (until the light starts alternating red / green and the lid opens and closes).

Look at your Wi-Fi settings and make sure you are using a 2.4gHz network. Check if any firewalls are activated on your router to keeping it from connecting. Power cycle the feeder by turning off the power switch. Wait 10 seconds and turn the power switch back on.

Press and hold the Up button and the Down button for three seconds to reset the feeder to factory settings. When the feeder is powered on, press the button once and the feeder will dispense one portion of food.

Yellow Blinking Feeder has power and is in setup mode. Yellow Solid Smartphone is connected to the feeder in setup mode. Blue Blinking Slow Feeder is connected to Wi-Fi but no internet. Blue Blinking Fast Feeder is trying to connect to Wi-Fi or is offline.

The MCLR pin can be used to generate a reset. On most PICmicro® devices the MCLR pin is always active.

Use the AAHA online microchip lookup tool to see if your pet's microchip has been registered and to update the information. If the chip hasn't been registered, you can simply register it with your name and contact information.

Yes, it is possible to remove a microchip from your pet; however, it is a more difficult and expensive procedure than getting it inserted. This is because removing a microchip requires a full surgical procedure.

Locate your computer's network settings, and search for nearby Wi-Fi networks. Select your network, and enter your password. If the connection is successful, open your web browser and try navigating to a webpage like www.google.com. If the page loads, it means your Wi-Fi connection is working correctly.

How do I access portable Wi-Fi? ›

To make a portable wifi work, you have to simply turn the device on, make sure there is a SIM card in it, and you're done. Quite easy. Also, the portable wifi does work on a battery, so it is necessary that you keep the device charged at all times. The device does not work like a normal broadband connection.

How to restart the Fresh Element Mini Pro? Unplug the power cord and plug it in again to restart the device. If there are batteries in the device, remove the battery and reinstall it.

Go the pet feeder' settings page, look for “remove device” Remove it and reset the pet feeder and pair it again through the app.

Yellow Blinking Feeder has power and is in setup mode. Yellow Solid Smartphone is connected to the feeder in setup mode. Blue Blinking Slow Feeder is connected to Wi-Fi but no internet. Blue Blinking Fast Feeder is trying to connect to Wi-Fi or is offline.